Revel - #4 TACK-FREE UV GEL TOP COAT 0.5 fl oz
This product is only available on our website and is shipped directly from our partners. Please be aware that shipping costs may apply.
Earn [points_amount] when you buy this item.
Disclaimer
Please be aware that the information on the product packaging may differ from what you see on our website. This includes details like product descriptions, where it's from, nutrition facts, ingredients, and allergy warnings. It's important to carefully check the packaging before using our products to know how to use them, possible risks, and any precautions.
We try our best to give accurate and up-to-date information on our website, but sometimes there might be mistakes. If there's any difference between the website and the packaging information, please follow what's on the packaging.
Report a product problem
If you have any problem with the product, please fill out the following form
What it is:
Revel's Tack-Free Gel Topcoat is a Gel alternative to our standard Finish Gel. Must use with UV/LED light. See below, How to Cure, for more details.
How to Cure:
When using on Revel Nail Dip Powder, omit the second coat of Activator, apply a thin coat of the Tack-Free Gel Topcoat, then cure under a UV/LED light for 90 seconds. Please note that this product requires a 36-48 WATT UV/LED light to cure properly.
Why Revel Tack-Free Gel:
Our Tack-Free Gel Topcoat offers high-gloss shine with a tack-free finish that will WOW you! It cures in 90 seconds under UV/LED lamps and can be used with either builder gel or acrylic systems. This product is not intended for soak-off builder gel.
STEP ONE: PREP NAIL
- Prepare by sanitizing hands and pushing back cuticles.
- Using a fine drill bit or buffer/file, remove shine from nails.
- It is recommended to file down any excess length of your natural nail.
STEP TWO: SIZE TIPS
- Tips should fit your natural nail from sidewall to sidewall naturally without applying pressure.
- If you are in between sizes, size up and file sides if necessary.
STEP THREE: PRIME NAIL
- Remove any dust from nails and skin by wiping the nail clean with alcohol.
- Apply “Prep | Nail Dehydrator” to nail in one thin coat.
- After nail is fully dry apply “Prime | Acid-Free Primer” to entire nail in one thin coat.
STEP FOUR: BASE GEL
- Apply a thin layer of “Bond” to all natural nails and cure in a LED lamp for 60 seconds or 2 minutes for UV.
- Apply a thin coat of “Prime” to the inside of the nail tips using the brush to scrub the product into the tip.
STEP FIVE: APPLY TIP
- Apply “Bond” to the inside of the gel tip where it contacts that natural nail.
- Press the tip to the nail at an angle starting at the base of the nail and slowly push downward, allowing the gel to spread to the free edge.
STEP SIX: FLASH CURE
- While holding down the tip in place, flash cure with Spectra Flash Cure UV/LED Lamp for 15-20 seconds.
- Carefully repeat steps 5 and 6 to apply gel tips on the rest of your nails.
STEP SEVEN: CURE & SHAPE
- Fully cure all nails in a LED lamp for 60 seconds or 2 minutes for UV
- Once nails are cured and secured, file and shape the tips to your liking.
STEP EIGHT: FINISH MANI
- Proceed with your favorite shade of Lacquer, Gel Polish, or Dip Powder to finish out your manicure.
- Seal and protect your manicure with Tack Free Gel Top Coat and cure for 90 seconds in a UV/LED lamp.
Compare products
{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}